How To Install Hinge Pin Door Stops ?

Degol : How To Install Hinge Pin Door Stops ?

First close the door completely and slide the tip of the screwdriver under the hinge head. It will be on the upper hinge of the door. Then look up at the hinge pin and remove it. After that, tap the screwdriver lightly to pull the pin into place. If the screwdriver does not rotate to tighten the pin, use the hammer lightly.

Now, insert the hinge pin into the hole of the door stop from above. The pin will extend below the hole for perfect assembly. Gently rotate the pin back to the hinge. It helps the stopper to be assembled on the hinge by fixing the pin in its position. Now, fix the pin into the hinge by tapping lightly with a hammer.

After the hinge is installed, screw the screw to the rubber buffer so that the door can swing to the maximum angle. The stopping position of the door depends on the rotation level of the screw. The more you screw, the faster the door will stop. However, open the door to test, and if there are any problems, adjust the settings before finishing and do whatever you want.

Remember, hinge pin door stops are more reliable for heavier doors, and fixed column door stops are more reliable for lighter doors.