Lock installation

An experienced carpenter or a master with considerable knowledge of locks should be hired for installation. And according to the fixed-distance model in the product manual, drill holes, chisel the support socket, the lock plate and the lock box hole, so as to make preparations before installation.

Check whether the drilled holes are accurate, and strictly follow the steps in the product installation manual. If you find that the lock switch is inflexible or cannot be opened after installation, you should consult a locksmith in time. The dealer of the product or the technical service department and after-sales service department of the manufacturer so that the problem can be solved. 

If there is no problem with the product installation and inspection, remove the product, and reinstall the lock after the door is painted and dried (it is recommended to be more than two or three days). The purpose is to prevent the paint from sticking to the door. On lock products, it affects the appearance and performance (often because the paint sticks to the lock and makes the transmission inflexible). When the paint is not dry, the gas of the chemical will corrode the product, accelerate the change of the surface treatment of the product, affect the appearance and reduce the The service life of the lock.

During the renovation of the house, please use a plastic bag (do not touch the rubber surface of the self-adhesive tape with the surface of the lock) to seal the exposed parts such as the handle and panel of the lock, so as to prevent the surface treatment layer of the lock parts from being acidic or damaged during decoration. The erosion of alkaline materials and gases will cause spots, blisters and even delamination, which will seriously affect the appearance quality of locks.